Pre-Collision System Retrofit
#46
A slew of people have messaged me asking where this project stands. The gist of it is that most of the connectors I ordered from China and Japan are either on a slow boat or stuck in customs. I have all the parts I need. In the mean time, I have been creating the harness which is going pretty well. Until I can get those connectors landed at my door step, I can't make any more progress.
The following users liked this post:
Measured (10-09-20)
#50
I was planning on doing that this weekend and I still might but you probably saw the snow we got hit with today... got 8 inches pretty quickly. If I am in the mood after clearing my driveway I will do it. And no, if anything I will create a new hole in the firewall rather than screwing around with factory harness. Since I have warranty I want to keep electrical portion as stock as possible.... you know..just in case lol
The following users liked this post:
NoMSGadded (01-19-21)
#56
Yes, GS350 does not have all speed, only down to 37km/h lol. It's okay I don't mind.
#57
@Justin0807 I am not installing the Lane Recognition Camera, just the Driver Monitor and DRCC. But good job on hooking it up.
@bclexus The connector I cannot find is for the Driving Support ECU Assembly (p/n 90980-12708). I will need to probably buy a harness that has it already and re-use it.
@bclexus The connector I cannot find is for the Driving Support ECU Assembly (p/n 90980-12708). I will need to probably buy a harness that has it already and re-use it.
The following users liked this post:
eddie420 (11-16-18)
#59
You didn't need the driver monitor camera, that's mounted to the steering wheel?
Please list the parts you installed and more info on the custom wiring you did.
Please list the parts you installed and more info on the custom wiring you did.
Last edited by peasodos; 11-16-18 at 09:24 PM.