GROM VL2 installed
#1066
Driver School Candidate
Although, 50% of the time it doesn't work at all.
The following users liked this post:
wannano (08-14-21)
#1070
Driver School Candidate
Edit:
Ugh, they're making me do all the basic steps. Update (already did), factory reset, etc. Be prepared to waste a bunch of time.
Last edited by ShadeXero; 07-26-21 at 01:55 PM.
The following users liked this post:
ShadeXero (07-26-21)
#1072
Instructor
Thread Starter
I'm seeing same issue in my RLX on WAA. GROM will fix it soon, I hope. Had to switch back to OEM navigation on the way home Saturday night.
#1075
Driver
iTrader: (1)
Bob - here is mine mounted under the pull out tray in the center console. Fits perfect and frees up space in the glove box (wife uses it to store grocery bags). The power cable was just long enough - I wish I had 2 more inches. Ran the wires down the right side of the center console. As Eddie said - there lots of room there.
This is just perfect and exactly what I want to do. Just a few questions before I do the same thing. What did you do about the gps receiver ? Where was that located?
#1076
Driver
iTrader: (1)
Finish my install today...
Cut a small open in filter door to route harness. Didn't want to hack up my glove box, so this is more reasonable.
Mount VL2 with some automotive grade Velcro. Easy to remove if I need to access cabin filter.
Zip tied everything down for nice OEM look. Don't know what all these HDMI and VGA ports are for. Maybe future expansion..front cameras? Full Android Auto and Car Play are supported in the future with those USB ports.
Route GPS to passenger pillar. Looks very OEM.
Cut a small open in filter door to route harness. Didn't want to hack up my glove box, so this is more reasonable.
Mount VL2 with some automotive grade Velcro. Easy to remove if I need to access cabin filter.
Zip tied everything down for nice OEM look. Don't know what all these HDMI and VGA ports are for. Maybe future expansion..front cameras? Full Android Auto and Car Play are supported in the future with those USB ports.
Route GPS to passenger pillar. Looks very OEM.
How come your aux port is occupied ? I though the Grom uses the factory mic for the GS 350 ?
#1078
Driver
iTrader: (1)
I wish I had a better picture to explain what I am talking about. If you remove the center trim behind the cupholders, there is a lot of space to route wires into the bottom compartment under the tray. To me that was dead space I was not going to use for anything. Frankly, you can mount it anywhere you see fit, but the center console has good depth to mount this or any similar dimension items down there. Sorry I can't explain this better.
#1079
#1080
Instructor
Thread Starter
I'd highly recommend you don't put VL2 unit somewhere you can't get to. You will need access to the unit to pull the harness cable in-case you need to hard reboot. Glove box is the best place and it is what GROM recommends. Just follow my install guide it's pretty detailed.
The following users liked this post:
abapper (10-06-21)