Replaced Right Outisde Mirror - BSD Errors
#16
Instructor
Thread Starter
Got it all in and rebuilt the mirror. The broken tab deformed before it snapped so when I glued it back, the hole was off by 1/4" so I had to drill it out and make it slotted. It went together OK after that. Now, to swap it out tomorrow.
Pics for your entertainment.
New parts.
Assembled mirror. Good paint match.
Assembled mirror.
Pics for your entertainment.
New parts.
Assembled mirror. Good paint match.
Assembled mirror.
The following 3 users liked this post by Knucklebus:
The following users liked this post:
bclexus (02-03-23)
#18
Instructor
Thread Starter
I only caught the edge of the garage door weather strip with the outside plastic of the mirror housing. I've been backing this car into the garage for 5 years. The mirror was cracked from a previous owner's incident. I suspect that's why it blew apart instead of folded. When I went to disassemble it for the new cover, several of the screws weren't even tight in the studs, of which every single one broke.
On another note, I got a refund for the poorly matched rattle can paint.
#19
Lexus Test Driver
#20
Instructor
Thread Starter
#21
Instructor
Thread Starter
New mirror cover on old mirror guts is back on and everything seem to be working again. It moves, BSD doesn't give an error and the mirror lights up and the puddle light and turn signal works. I'm getting good at pulling the door panel.
#22
Lexus Test Driver
Thread
Thread Starter
Forum
Replies
Last Post
Runamok81
GS - 4th Gen (2013-2020)
10
04-08-17 02:15 PM