aluminum mode switch cover
07-24-18, 06:00 PM
#20
Pit Crew
I'm, in. Mine has chipped paint several places, even started a thread about it a while back lol. This would be perfect. Where'd OP go? I'm all excited over here lol
07-24-18, 06:35 PM
#21
Pole Position
07-25-18, 09:11 AM
#23
Rookie
Thread Starter
MSRP was 9,000 JPY plus local shipping so I would say somewhere around $100 plus airfreight?
I think the freight would be like $10 via EMS to the states no matter what the quantity.
Please let me know if you are still interested.
I think the freight would be like $10 via EMS to the states no matter what the quantity.
Please let me know if you are still interested.
07-25-18, 09:20 AM
#24
Rookie
Thread Starter
And by the way the lower ring is secured by double side tape but the switch cover is not actually adhesed to the factory switch.
I mean, you CAN use double side tape but the instructions told not to and use vinyl tape instead.
You place 1 or 2 layers of vinyl tape on the inside and kind of squeeze it in.
Not sure if I am explaining it right.
I mean, you CAN use double side tape but the instructions told not to and use vinyl tape instead.
You place 1 or 2 layers of vinyl tape on the inside and kind of squeeze it in.
Not sure if I am explaining it right.
The following 2 users liked this post by hageuzai:
eddie420 (07-25-18),
LatinLS430 (07-25-18)
07-25-18, 10:01 AM
#26
Ouch $110? Too expensive for me. $50 maybe.
07-25-18, 02:14 PM
#27
Instructor
