GSF Has Power But Won't Start
#16
Driver School Candidate
Thread Starter
Join Date: Dec 2022
Location: VA
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
It's a possibility. I went through the engine but couldn't find anything chewed up. Maybe something got wet?
Last edited by Khun89; 12-31-22 at 09:38 AM.
#18
Pole Position
#20
Pole Position
It's by the front of the crank on the side though, look for a small wiring harness that goes into the timing chain lower cover. I don't know if a problem there will cause the light on the push start button to not light up though, if you have an open there it wont start but wont cause any of the problems like flickering lights etc.
Last edited by Gerf; 01-01-23 at 12:06 PM.
#21
Pole Position
Not your engine but they're all basically in the same spot, where it says crankshaft position near the bottom.
#23
Pole Position
#25
Pole Position
Clear the code and see if it comes back immediately (hard code) I wouldn't chase that too far if it doesn't.
#28
Pole Position
So the code comes back when clearing it and then turning the ignition on with no attempt to crank it over?
#30
Pole Position