GS - 3rd Gen (2006-2011) Discussion about the 2006+ model GS300, GS350, GS430, GS450H and GS460

RPM doesnt go pass 3 while driving

Thread Tools
 
Search this Thread
 
Old 12-14-10, 09:07 AM
  #1  
koolguy1
Driver School Candidate
Thread Starter
 
koolguy1's Avatar
 
Join Date: Jul 2010
Location: tx
Posts: 9
Likes: 0
Received 0 Likes on 0 Posts
Default RPM doesnt go pass 3 while driving

hi does anyone know what kind of problem i am looking at if my 06 gs 300 wont go pass 3 while im driving? its nomally at around 2 and if i floor it it goes up to 3 and thats it. thanks
Old 12-14-10, 10:22 AM
  #2  
BinaryJay
Pole Position
 
BinaryJay's Avatar
 
Join Date: Oct 2009
Location: Toronto
Posts: 3,154
Likes: 0
Received 14 Likes on 13 Posts
Default

No check engine light? Sounds like "limp mode", but limp mode should be accompanied by dummy lights.

Barring that, transmission stuck in high gear? Are you in "snow mode" or something? It should definitely go all the way up to red line when flooring it in sport mode.
Old 12-14-10, 10:52 AM
  #3  
rominl
exclusive matchup

iTrader: (4)
 
rominl's Avatar
 
Join Date: May 2002
Location: Lovely OC
Posts: 81,673
Received 190 Likes on 148 Posts
Default

sounds like limp mode to me as well. tell us exactly what other lights you see on the dash board
Old 12-14-10, 01:34 PM
  #4  
GS350Lexus
Lexus Champion
iTrader: (5)
 
GS350Lexus's Avatar
 
Join Date: Aug 2009
Location: NY
Posts: 2,741
Received 3 Likes on 3 Posts
Default

To me its more like a gas saver mode , But you should be expecting few dummy lights on you're car in order to have this so called "limp mode".
Old 12-14-10, 03:05 PM
  #5  
designo
Pole Position
iTrader: (6)
 
designo's Avatar
 
Join Date: Sep 2009
Location: Bahrain
Posts: 3,425
Received 470 Likes on 292 Posts
Default

Air Flow Meter needs to either be cleaned or replaced.
Old 12-15-10, 07:49 PM
  #6  
spine911
Lead Lap
iTrader: (4)
 
spine911's Avatar
 
Join Date: Jan 2009
Location: ca
Posts: 440
Likes: 0
Received 0 Likes on 0 Posts
Default

Originally Posted by koolguy1
hi does anyone know what kind of problem i am looking at if my 06 gs 300 wont go pass 3 while im driving? its nomally at around 2 and if i floor it it goes up to 3 and thats it. thanks

EXACT same problem my car presented with;

....mine choked/stuttered @ 5k RPMs; when i posted this query here.

https://www.clublexus.com/forums/gs-...-5000rpms.html


upon further research, i discovered that the 3GS (gs300/350) had a DEVELOPING problem....I had my car repaired by Lexus under a TAS (Technical Assistance Service) case looooong before the TSIB fix.

https://www.clublexus.com/forums/gs-...ng-help-3.html

read post #31, and #44; (notice the trending before post #31 = all are 300s/350s).
link attached on a Lexus TSIB fix for Carbon Buildup.
unfortunately, the TSIB fix for carbonization is only for cars with symptoms that are replicable by your dealer.

yes, the TSIB solved the stuttering, hesitation, rough idle..........not quite sure if it will prevent any future buildup.
Old 12-16-10, 05:03 AM
  #7  
BinaryJay
Pole Position
 
BinaryJay's Avatar
 
Join Date: Oct 2009
Location: Toronto
Posts: 3,154
Likes: 0
Received 14 Likes on 13 Posts
Default

Originally Posted by spine911
EXACT same problem my car presented with;

....mine choked/stuttered @ 5k RPMs; when i posted this query here.

https://www.clublexus.com/forums/gs-...-5000rpms.html


upon further research, i discovered that the 3GS (gs300/350) had a DEVELOPING problem....I had my car repaired by Lexus under a TAS (Technical Assistance Service) case looooong before the TSIB fix.

https://www.clublexus.com/forums/gs-...ng-help-3.html

read post #31, and #44; (notice the trending before post #31 = all are 300s/350s).
link attached on a Lexus TSIB fix for Carbon Buildup.
unfortunately, the TSIB fix for carbonization is only for cars with symptoms that are replicable by your dealer.

yes, the TSIB solved the stuttering, hesitation, rough idle..........not quite sure if it will prevent any future buildup.
It sounds like what he's describing is different, it sounds like his car will not allow an engine speed above 3000 rpm which is a typical limp mode symptom. My guess is one of the engine sensors like a cam position has gone bad according to the ECU and it has gone into safe mode to try to prevent damage to the engine. Of course, again, this would always be accompanied by a christmas tree dash. Anyway, the OP is not responding so we'll never know.
Old 12-16-10, 07:34 AM
  #8  
designo
Pole Position
iTrader: (6)
 
designo's Avatar
 
Join Date: Sep 2009
Location: Bahrain
Posts: 3,425
Received 470 Likes on 292 Posts
Default

From my experience, limp mode with no error message has always been due to bad MAF's.

Also referred to as mass air sensors!

Have it checked out
Old 01-19-11, 03:53 PM
  #9  
kdouglas39
Rookie
 
kdouglas39's Avatar
 
Join Date: Jun 2010
Location: TX
Posts: 61
Received 0 Likes on 0 Posts
Default

Where is the air flow meter?
Old 01-19-11, 04:33 PM
  #10  
BinaryJay
Pole Position
 
BinaryJay's Avatar
 
Join Date: Oct 2009
Location: Toronto
Posts: 3,154
Likes: 0
Received 14 Likes on 13 Posts
Default

Originally Posted by kdouglas39
Where is the air flow meter?
First thing north of the air cleaner on the intake tube, attached to an electrical harness and fastened to the tube with two small screws.
Old 01-24-11, 10:43 AM
  #11  
kdouglas39
Rookie
 
kdouglas39's Avatar
 
Join Date: Jun 2010
Location: TX
Posts: 61
Received 0 Likes on 0 Posts
Question Pcv

Originally Posted by BinaryJay
First thing north of the air cleaner on the intake tube, attached to an electrical harness and fastened to the tube with two small screws.
Trying to located my PCV on my 2006 GS 300. is it connected to the intake tube?
Old 01-24-11, 12:42 PM
  #12  
BinaryJay
Pole Position
 
BinaryJay's Avatar
 
Join Date: Oct 2009
Location: Toronto
Posts: 3,154
Likes: 0
Received 14 Likes on 13 Posts
Default

Originally Posted by kdouglas39
Trying to located my PCV on my 2006 GS 300. is it connected to the intake tube?
Top rear passenger side of engine where the throttle body is.
Old 01-24-11, 01:02 PM
  #13  
designo
Pole Position
iTrader: (6)
 
designo's Avatar
 
Join Date: Sep 2009
Location: Bahrain
Posts: 3,425
Received 470 Likes on 292 Posts
Default

Originally Posted by BinaryJay
First thing north of the air cleaner on the intake tube, attached to an electrical harness and fastened to the tube with two small screws.
Circled in this picture

Last edited by designo; 04-24-11 at 03:25 AM.
Old 01-24-11, 07:39 PM
  #14  
kdouglas39
Rookie
 
kdouglas39's Avatar
 
Join Date: Jun 2010
Location: TX
Posts: 61
Received 0 Likes on 0 Posts
Default

BinaryJay, do you have a pic of where its located. Is it located by the sparkplug and has a connector on the top of it?

Last edited by kdouglas39; 01-24-11 at 07:52 PM. Reason: added question
Old 01-25-11, 07:07 AM
  #15  
JL6speed
Driver
 
JL6speed's Avatar
 
Join Date: May 2006
Location: TX
Posts: 84
Likes: 0
Received 0 Likes on 0 Posts
Default

Happened to my cousin's G35 when he had a CAI and drove into a large puddle when it rained a lot lol. But his CEL came on and later blew his motor.


Quick Reply: RPM doesnt go pass 3 while driving



All times are GMT -7. The time now is 01:24 PM.