What did you do to your GX TODAY?
#901
Pole Position
Where'd you buy the bulbs? Link? Any pics of the light output?
#902
Not really easy to get quality pic of light output on the reverse lights, I’ll try this evening. The light is amazing. Best light mod I have done to the GX so far. I bought them off of V-leds.com
Last edited by Tdoll; 11-10-17 at 07:54 AM.
#903
I got the bulbs from V-Leds, very expensive, but totally worth it for me.
http://www.vleds.com/shop-products/l...40-6-ho-c.html
http://www.vleds.com/shop-products/l...40-6-ho-c.html
#904
Performed 150k mile service today
Oil/Filter 6.5 qt
Air filter
Cabin filter
Brake Flush
Coolant -i skipped this since it was replaced with timing belt at 90k with Super Long Life coolant
Front diff fluid 1.5 qt
Transfer case fluid 1.5 qt
Rear diff fluid 3.3 qt
Tire rotation
Grease all zerks fittings
Top off fluids
Oil/Filter 6.5 qt
Air filter
Cabin filter
Brake Flush
Coolant -i skipped this since it was replaced with timing belt at 90k with Super Long Life coolant
Front diff fluid 1.5 qt
Transfer case fluid 1.5 qt
Rear diff fluid 3.3 qt
Tire rotation
Grease all zerks fittings
Top off fluids
The following users liked this post:
Kalel250 (12-05-17)
#906
Pole Position
Oil + Filter change, and replaced not one but TWO TPMS sensors that had died. Hopefully that's the last of them.
Word of advice - if you're putting new tires on a 10 year old vehicle, go ahead and change all the sensors. That way you'll only pay for demounting/mounting/balancing the tires once. This has been a total PITA to wait for each one to die and change it out individually.
Chip H.
Word of advice - if you're putting new tires on a 10 year old vehicle, go ahead and change all the sensors. That way you'll only pay for demounting/mounting/balancing the tires once. This has been a total PITA to wait for each one to die and change it out individually.
Chip H.
#907
#908
Pole Position
Most of the tire shops have OBD software that will show the pressure that the sensor is reporting. If it's saying 0 psi and the tire obviously isn't flat, then the sensor is bad. Or if it's reporting any pressure that is wildly different from what actually measuring it through the valve stem says.
The dealer's OBD software (and any of the "high-end" software programs) has the ability to read the actual battery voltage of the sensor. So if it's below 3v then you know it's on the way out.
In my case, the spare was reporting 1.9v (on it's way out) and the front right was 0v (totally dead).
Chip H.
The dealer's OBD software (and any of the "high-end" software programs) has the ability to read the actual battery voltage of the sensor. So if it's below 3v then you know it's on the way out.
In my case, the spare was reporting 1.9v (on it's way out) and the front right was 0v (totally dead).
Chip H.
#912
Pole Position
#913
Driver School Candidate
#914
Yes, the LED is much brighter. They are both eBay kits. The LED light spreads out (no brighter spot) more than the HID and stock halogen. But overall it is greater.
Last edited by tz693; 12-06-17 at 10:39 AM.