Center console Piece trashed!
#1
Lexus Test Driver
Thread Starter
Center console Piece trashed!
Had a little mishap this weekend and left a can of Injector cleaner in my center case and I guess the lid was not on tight and leaked onto this piece of plastic so my question is can I get just this little trim piece or what parts/pieces do I need. thanks!
#2
Pole Position
You can only get the next-higher assembly which is the entire thing. You aren't going to like the price - $300 over the internet, $400 list price.
http://www.lexussouthatlantaparts.co...rimLevel=19100
The good news(-ish) is that this appears to include the cupholder and storage boxes, including their doors.
The bad news is you'll probably have to remove both front seats to access the screws on the side of it.
Chip H.
http://www.lexussouthatlantaparts.co...rimLevel=19100
The good news(-ish) is that this appears to include the cupholder and storage boxes, including their doors.
The bad news is you'll probably have to remove both front seats to access the screws on the side of it.
Chip H.
#5
^^^Agreed. Its painted as it is, so I think you'll be fine patching it up with bondo and painting it the factory color they used.
Which probably will cost roughly the same price as buying the whole thing?? I don't know. Haha
Which probably will cost roughly the same price as buying the whole thing?? I don't know. Haha
#7
I see center consoles on eBay all the time. Prices vary but IMO you can go as-is until you find one either at a salvage yard or eBay. I needed a hood replacement for my other car - wasn't going to pay $2200-2500 to fix. Took about 3-4 months but finally found one in TX and had shipped for $935.00 - matches the paint darn near perfect... Just kept checking...
Trending Topics
#8
Pole Position
Agree - this is the opportunity for a parts-yard replacement. Not sure if they'll be any cheaper (those guys are pretty sharp businessmen...), but it can't hurt to check.
Otherwise, yeah, plan B would be to remove it and see if a body shop can Bondo it up to bring the surface back level. Then you can put some of the vinyl wrap material on it - they make it in brushed metallic. Or just paint it.
Chip H.
Otherwise, yeah, plan B would be to remove it and see if a body shop can Bondo it up to bring the surface back level. Then you can put some of the vinyl wrap material on it - they make it in brushed metallic. Or just paint it.
Chip H.
Thread
Thread Starter
Forum
Replies
Last Post