Where is my bank 1 sensor 1 located? (P0031 code)
#1
4th Gear
Thread Starter
Where is my bank 1 sensor 1 located? (P0031 code)
I got a P0031 code - H20S heater control circuit low bank 1 sensor 1
I had recently repaired a rat chewed wire (in picture ) and thought that might be reason for code. I have erased code twice and has come back both times after test driving for a bit.
I’m assuming might be another rat chewing problem at o2 sensor. Haven’t found an online resource to show me exactly where it’s located.
Thanks for your time.
I had recently repaired a rat chewed wire (in picture ) and thought that might be reason for code. I have erased code twice and has come back both times after test driving for a bit.
I’m assuming might be another rat chewing problem at o2 sensor. Haven’t found an online resource to show me exactly where it’s located.
Thanks for your time.
Last edited by binkyrules; 03-10-21 at 07:11 PM.
#2
Pole Position
It's going to be below that area. Driver's side, ahead of the catalyst.
Chip H.
Chip H.
The following users liked this post:
binkyrules (03-12-21)
#3
Pole Position
Bank 1 should be driver's side, sensor 1 will be the pre-cat O2 sensor.
I'm glad we don't need to really worry about rat damage around here!
I'm glad we don't need to really worry about rat damage around here!
Thread
Thread Starter
Forum
Replies
Last Post