When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I did get the package. Not sure if my emails helped bring attention back to it, but once the tracking number dropped it was around a week to get from Dubai to my door.
Got the Crawl switch installed and calibrated tonight. I went with the @Nickk6 method of keeping the blanks for the top two buttons, and having "stealth crawl" under the guise of a DAC switch.
Probably about an hour, but I had taken apart a lot of those parts before so I just dove right in. The lower kick panel below the box is a bit tricky and the clips are pretty tight. I didn't remove the whole thing - just enough to get the interior of the glove box out of the way so I could stick my hand in there to unbolt the old computer. Budget a couple hours if you haven't been in there already.
The remote start install instructions are also a good tutorial for taking dash apart. The remote start module is installed to the right of the Driver Support ECU
Got the MTS computer installed and the console switch swapped. Is there a trick to install the passenger kick panel? Also, I have not had a chance to calibrate for the new switch, would there be a problem driving the car before calibration?
Got the MTS computer installed and the console switch swapped. Is there a trick to install the passenger kick panel? Also, I have not had a chance to calibrate for the new switch, would there be a problem driving the car before calibration?
Do you have a picture of where things aren't meshing up? Only tricky part I had was removing the knee air bag.
It should be fine driving without calibration. You just wouldn't be able to use DAC.
I was able to put on the kick panel this morning. When I took it off, I removed the clip and forgot how it goes back on. I finally figured it out. I will try to calibrate it tonight.
got the car calibrated but something weird is happening. The VDC light is on constantly. I try to activate the crawl control but the on/off switch does nothing. The sequence I use is to put the car in Neutral, put car in 4lo, then shift into Drive and turn on Crawl button but it does nothing. I might have to calibrate again. Has anyone ran into this before? MTS is recognized and I could set the car in different terrains.