When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
i ordered the above parts from oemvehicleparts website. It is now 11 days from my order date. The part is yet to come. They are blaming the covid and the post office has lot of packets to handle in florida. Why they are using USPS priority mail. They could use ups instead
USPS status still says "label created, USPS awaiting item"
I’m not going to add crawl at this time. I was going to order from One of the sites listed in this thread. I think oemvehicleparts has a shipping discount. I’ll have to page through to find it.
Check out carmarka based out of UAE. I got both my MTS and Crawl from them and it was around $333. That included shipping from UAE to USA. I remember it coming in a lot cheaper than the US parts distributors. Keep it in mind if you wanted to do both and wanted to save a few $.
For anyone who has reservations doing this mod, it was literally 20 minutes start to finish. I watched both of Veliksam's videos, grabbed a phillips screwdriver, pair of needle nose pliers (squeeze wire harness and switch retainers) and two paper clips. Wham, bam, done. I tested it out in my gravel driveway. works as advertised. Sure makes a lot of braking noise set on the two lowest speeds on flat ground though. Med - hi were smooth.
MTS driver module gets here Tuesday...hopefully.
Hi All
i am all set to install crawl, MTS modules. I am concerned about driving straight after install. If i install in my garage, it will be reverse and different directions before set to drive straight for atleast 15 seconds. When will the straight driving calibration takes place. Would it take it wrong if we drive not straight after installation.
Acrad and others please, what is the right calibration.
Hi All
i am all set to install crawl, MTS modules. I am concerned about driving straight after install. If i install in my garage, it will be reverse and different directions before set to drive straight for atleast 15 seconds. When will the straight driving calibration takes place. Would it take it wrong if we drive not straight after installation.
Acrad and others please, what is the right calibration.
You'll just have lights on the dash until you calibrate. The vehicle is still safe to drive.
You'll just have lights on the dash until you calibrate. The vehicle is still safe to drive.
Thanks klinquist, so the idea is install everything and go to a place where straight driving is possible and do the zero calibration and drive straight.
Thanks klinquist, so the idea is install everything and go to a place where straight driving is possible and do the zero calibration and drive straight.