When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I’m in process ordering full Sport Design kit from car-act.
all parts are painted and ready to be installed.
grill come prepaiinted black
front and rear lip come prepainted sport design grey/silver
mirror cover come Prepainted in black or white color.
chrome strips are chrome
full kit about $1650
now I’m looking for install guide to figure out if drill is needed for mounting points
I ordered the front lip and grille from car act as well (without the rear, because I didn’t like the look with the tow hitch).
the front lip DOES require drilling into your front bumper, that’s why I have not installed it yet after receiving for a month. The grille wasn’t too bad to install, although I think it would have been easier if the front bumper was removed.
3M rubber photo below. Not sure where I can get more of this. You can see the gap without this rubber.
Regarding the drill point, I just drill it directly into the bumper with the provided screw. There not any specific point. It really pretty to install the setup. Only took my 2.5 hours for grille and kit This is an extra piece where I just temporarily attached between kit and bumper to show u guys.
Here’s another up close of the kit without the rubber piece. It looks fine without it, but it will look much cleaner with it. I’m still searching around for a replacement.
I have all the parts from Car-Act but waiting for additional grey and white rubber seals. I asked for grey and white (the kit came with black seal only). I may use additional 3M tape just to be on the safe side.
Quick question, brian7787, did you have to remove the lower vent piece in the front or does it just mount over them? I haven't gotten a chance to dry fit them yet. I just got them back from the paint shop. Thanks.