Automatic Window Disable
#1
Driver School Candidate
Thread Starter
Automatic Window Disable
I just installed a set of in channel vent visors on my 2010 Base. The Drivers window goes up and stays no problem, the other three go up, hit resistance and go back down. In fact, I think the front passenger window doesn't go up all the way before it comes down half way.
Is there a way to disable this feature? Otherwise, I'll just remove them and send them back.
Thanks,
jaaydee
Is there a way to disable this feature? Otherwise, I'll just remove them and send them back.
Thanks,
jaaydee
The following users liked this post:
Acrad (09-07-20)
#3
Driver School Candidate
Thread Starter
#5
Driver School Candidate
Thread Starter
#6
Racer
You can reset it so it see if it helps. Roll it all the way up, then hold it for a few seconds to reset.
#7
Driver School Candidate
Thread Starter
Trending Topics
#8
Racer
What I did after I installed WeatherTech was roll it up by slowly nudging the up button and not using automatic roll ip. Then when it’s all the way up, don’t let go of the button but keep holding it for a few seconds.
The following users liked this post:
Acrad (09-07-20)
#9
Driver School Candidate
Thread Starter
#10
Driver School Candidate
Thread Starter
thanks for the tip, I tried.
So if anybody wants to try them, I'll make them a good deal!
jaaydee
#11
FWIW, have you tried leaving the vents in the sun for a few hours. Then install, bend it out a bit, put the window up and then letting it sit overnight.
#12
Advanced
If you end up returning the in channels, there is a seller on eBay that has stick on versions that work really well! They are half the cost of weathertechs at $50 and do serve the same purpose.
The following users liked this post:
Acrad (09-09-20)
#13
Driver School Candidate
Thread Starter
#14
Driver School Candidate
Thread Starter
jaaydee
Thread
Thread Starter
Forum
Replies
Last Post