2022 GX Discussion - Black Line Edition in black and Nori Green Pearl/ AA CP 10.3"
#466
Super Moderator
Thread Starter
#467
I don’t know what we would do without you.
Next question - Can you retrofit an old one that is dimming?
#468
Super Moderator
Thread Starter
I haven't heard of anyone doing it but with some custom wiring should be doable. It won't be plug and play like your '11 was though.
#469
Racer
As Acrad said, you will need to some wiring for that. The auto dim is controlled by rearview mirror sensor, the easiest way to do is to wire the two wires through the A-pillor and tap into the rearview mirror harness. I had harness wiring diagram for 2014 GX placed somewhere, but Acrad might be able to locate the diagram quicker, assume the harnesses still the same for 2020+
#470
As Acrad said, you will need to some wiring for that. The auto dim is controlled by rearview mirror sensor, the easiest way to do is to wire the two wires through the A-pillor and tap into the rearview mirror harness. I had harness wiring diagram for 2014 GX placed somewhere, but Acrad might be able to locate the diagram quicker, assume the harnesses still the same for 2020+
#471
Super Moderator
Thread Starter
IMO: We will never have confirmation from Lexus... a '22 owner would have to take off the interior door panel to physically confirm
#473
Intermediate
#474
The following users liked this post:
catdaddylo (12-20-21)
#475
Lead Lap
That's one of those colors, in the right light, looks amazing. In another light, looks like runny diarrhea. They have one down the road. I like my blue, but it's currently worth more than I paid, so....
#476
Intermediate
I would like to make a suggestion for an easier install of the Curt hitch or for that matter any hitch. The Curt hitch with the top plate weighs somewhere around 10 lbs. I held it up with one hand while trying to get one bolt started with the other hand. The top plate had a tendency to slide around making getting the bolt hand started a pita. TIP use a jack to hold the hitch in place so you can use both hands to get that first bolt started. You don't won't to cross thread the bolt when you tighten it up. I didn't use a jack and I thought about it after I finished the install.
#479
Driver School Candidate
#480
https://www.clublexus.com/forums/gx-...l#post10371346
at one time those were the best. i still have them although i had to swap one out because the gx lapm housing got filled with water. theres a lot of discussion on bulbs in that thread. many arent good for continuous use: ones labeled canbus which have a dissipating resistor.
they shouldnt even call this canbus. theres nothing canbus about any of these.
at one time those were the best. i still have them although i had to swap one out because the gx lapm housing got filled with water. theres a lot of discussion on bulbs in that thread. many arent good for continuous use: ones labeled canbus which have a dissipating resistor.
they shouldnt even call this canbus. theres nothing canbus about any of these.