What Did You Do To Your Car Today?
#391
Driver
iTrader: (1)
Join Date: Aug 2011
Location: CA
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
Thanks man, I have some pics of the fitment on my car
http://www.flickr.com/photos/71747369@N02/7492613532/http://www.flickr.com/photos/71747369@N02/7492613532/ by http://www.flickr.com/people/71747369@N02/, on Flickr
http://www.flickr.com/photos/71747369@N02/7481443492/http://www.flickr.com/photos/71747369@N02/7481443492/ by http://www.flickr.com/people/71747369@N02/, on Flickr
http://www.flickr.com/photos/71747369@N02/7481456334/http://www.flickr.com/photos/71747369@N02/7481456334/ by http://www.flickr.com/people/71747369@N02/, on Flickr
http://www.flickr.com/photos/71747369@N02/7492613532/http://www.flickr.com/photos/71747369@N02/7492613532/ by http://www.flickr.com/people/71747369@N02/, on Flickr
http://www.flickr.com/photos/71747369@N02/7481443492/http://www.flickr.com/photos/71747369@N02/7481443492/ by http://www.flickr.com/people/71747369@N02/, on Flickr
http://www.flickr.com/photos/71747369@N02/7481456334/http://www.flickr.com/photos/71747369@N02/7481456334/ by http://www.flickr.com/people/71747369@N02/, on Flickr
Last edited by AGx858; 07-02-12 at 11:24 PM. Reason: pics
#397
http://www.youtube.com/watch?v=hW2i5-vyFJQ
i got out of work kinda late and had to wash all the bird sh#t off
i got out of work kinda late and had to wash all the bird sh#t off
#398
Driver
iTrader: (1)
Join Date: Aug 2011
Location: CA
Posts: 139
Likes: 0
Received 0 Likes
on
0 Posts
17x8 +35
17x9 +35
And I haven't measured them after but they should be in the low 20's. Fronts are x9 rear x10. When I get a chance I'll calculate everything.
And to reseal the lips and the barrels I used a automotive silicon sealant from home depot. I read that I should use a clear silicon sealant but I'm not sure if it makes much of a difference. The one I got was clear
#401
I've never used plasti-dip before but compared to the youtube videos it makes it a little harder to remove but not by much. I had like 5-7 layers of paint over the plasti-dip so it would peel off in little pieces as opposed to pulling it off in big chunks.
#403
Driver School Candidate
Join Date: Oct 2010
Location: FL
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
swapped my throttle body out earlier because of a bad throttle cable sensor. My brother helped me a bit and got it done in about an hour, felt like an accomplishment to us lol