Red Out Taillight DIY
#80
so i did 'em, and i've got to say that i like the car even that much more now.
pretty easy job. only took me about 30 mins(because i was being pretty careful). they are a slightly darker red, but my IS is black so i like the look.
anywho...here are a cpl pics...
pretty easy job. only took me about 30 mins(because i was being pretty careful). they are a slightly darker red, but my IS is black so i like the look.
anywho...here are a cpl pics...
#83
anybody wanna scan the template from the aerotect or create one for us DIY with the rvinyl? I dont wanna use an extacto knife as well, rather just use scissors and cut it from a template. but if i get desperate i mite just get both the rvinyl and aerotect.
#86
yeah, i'd try and make a template first. i got the precut ones 'cause i didn't want to mess around with an exacto knife near my tails.
how'd the tails turn out besides the scratches?
#87
I think doing a pre-cut will be too hard. I listened to R-vinyl's suggestion of not over saturating the taillight with water/deterg solution and I couldn't slide the film easily.
#89
but i think if you want the turn signal to blink red, you're going to have to put the red overlay on. otherwise it'll still shine through as amber with just the smoked tail overlay on
haven't tried it, but that would be my guess
#90
Lexus Fanatic
iTrader: (1)
I just did my red outs, extraordinarily simple, mine were pre cut
clean and dry the tailights
peel off the vinyl sheet, dip it in mild soapy water
position the vinyl, start squeegeeing towards the edges to get rid of bubbles and excess water, wipe off excess water
make sure it goes around curves without it popping up
The installation was very similar to the invisible shield product they make for electronic devices, i installed one of these on my nano and my bros PSP
clean and dry the tailights
peel off the vinyl sheet, dip it in mild soapy water
position the vinyl, start squeegeeing towards the edges to get rid of bubbles and excess water, wipe off excess water
make sure it goes around curves without it popping up
The installation was very similar to the invisible shield product they make for electronic devices, i installed one of these on my nano and my bros PSP