Junghyuk2

First, I'd like to thank everyone in CL for the knowledge & support...

I have 4 month old 06 CW 250..

I just installed Xenondepot HID last week,

after install (probably, not related), I noticed that the hood is not flushed with the both fenders..

Passenger side goes in more about 2~3mm, & squeezes the rubber strips...

is the factory hood adjustable?

is the hood hydraulics adjustable?

Thank you...

BobsGX

Open the hood and there should be 2 round rubber stoppers, 1 in each corner near the front corner of the hood. These are adjustable by turning left or right which will raise or lower that corner of the hood.

Junghyuk2

I was looking for them actually, but couldn't find them, i only saw rubber strips..

I'll go look again, it's on the fender, right?

Thank you..

Junghyuk2

I found em, and fixed em...

Thank you so much...