Tool For Removal Of Engine Cover Tabs?
#18
2IS OG
iTrader: (21)
OUCH!!! You shouldn't have paid that much, my friend. For anyone else looking for these clips, they are Lexus part # 90467-07211, and should cost roughly $1.74 each. If you get a price higher than that, call around to different Lexus dealers if it's possible/convenient for you. $5 a piece is waaaaay too much...
Javier
Javier
#20
Tech Info Resource
iTrader: (2)
See Javy's post above yours. There is no other source than Lexus. Just don't get ripped off because they jack the price through the sky.
#21
http://beta.lexus-parts.com/parts_de...id=61876&all=Y
is this the right part? Lexus OEM Radiator Support To Frame Seal Clip.. doesnt sound right.. but .97 a piece
just to make sure we are all on the same page. its the part of post #6?
is this the right part? Lexus OEM Radiator Support To Frame Seal Clip.. doesnt sound right.. but .97 a piece
just to make sure we are all on the same page. its the part of post #6?
Last edited by peterAP2; 09-04-07 at 11:40 PM.
#22
Lexus Champion
#25
Lexus Champion
#26
http://beta.lexus-parts.com/parts_de...id=61876&all=Y
is this the right part? Lexus OEM Radiator Support To Frame Seal Clip.. doesnt sound right.. but .97 a piece
just to make sure we are all on the same page. its the part of post #6?
is this the right part? Lexus OEM Radiator Support To Frame Seal Clip.. doesnt sound right.. but .97 a piece
just to make sure we are all on the same page. its the part of post #6?
can anybody verify this?
#28
2IS OG
iTrader: (21)
This from a post I made some time back about the engine cover clips:
The part number shown above from Sewell's site matches the one I have on my invoice, so the part number is right. They just put a picture of who-knows-what next to it.
Javier
I got mine from the dealer, mainly because I didn't feel like searching around for some other ones. We searched the exploded diagram of the engine bay on the parts department computer, and discovered they are Lexus part # 90467-07211, and cost $1.74 each. They've changed the clips, though - these fill out the hole better and don't break NEARLY as easily. However, they are unfortunately a bit more difficult to take out than the original clips. To take these out, you have to work your fingernail into the center lip of the button, instead of just pressing the small head all the way down like on the original clips. Anyway, I like the new ones WAY better than the old ones...
Javier
#29
Thank you sir. I will be ordering 3
#30
Driver School Candidate
Thread
Thread Starter
Forum
Replies
Last Post