DIY request: arm rest unit dissasembly
#1
DIY request: arm rest unit dissasembly
Hi all,
i just installed the vaistech sl2i, works great... i would like to take out my whole arm rest unit so i can drill to pass the cable through it, is there any DIY on this? i removed the 2 screws seen from the gear **** side but i still can't take the compartment out.
Hammy
i just installed the vaistech sl2i, works great... i would like to take out my whole arm rest unit so i can drill to pass the cable through it, is there any DIY on this? i removed the 2 screws seen from the gear **** side but i still can't take the compartment out.
Hammy
#3
Thanks Irishman, all what I had to do was to pull out the cup-holder/organizer in the arm rest compartment, shed in some light and viola!there’s a tiny engraved arrow on the bottom pointing to where you should insert a phillip screwdriver & it’ll pop right out.
Thread
Thread Starter
Forum
Replies
Last Post
lyonkster
GS - 2nd Gen (1998-2005)
29
12-09-10 01:53 PM