brociouz

iTrader: (65)

^ Yup, I haven't done it myself, but always hear heatgun and then some adhesive remover (Goo Goo kinda stuff, NOT acetone).

allst4r

iTrader: (7)

ive been taken mine off and putting it back on when i first installed it. make sure u take the visor part that attaches to your pillars near the middle of your car. then remove the part attach to the inside of your window,.

benzo555

iTrader: (11)

thanks guys. From what I remember there is adhesive and hooks. I wasnt sure which way to do it.

joeker

iTrader: (8)

heat gun, fishing line, and plenty of goo gone..

Bigrahizzl

iTrader: (8)

are u selling them???

516IS

iTrader: (12)

hehe, I might be interested too if you are able to take them off without a damage, PM me if so...

benzo555

iTrader: (11)

Please no PMs on the visors. I am trying to sell the car with them first if I get my asking price for the car. I will put a sales ad when its ready.

brociouz

iTrader: (65)

Merged threads.

I just removed my JDM visors - I used a hair dryer and dental floss. To remove the rear visors I heat up the end closer to the rear of the car and used the floss to cut through the adhesive. Be careful and gentle when pulling up since the metal bends easily. Be especially careful with the metal clips - there are two per each visor.

To remove the front visors I started again with the end closer to the rear of the car and used dental floss to start the process. My biggest piece of advice is to take your time and let the hair dryer/heat gun soften the adhesive.