xxjtp1xx

iTrader: (4)

Hey everyone! I recently bought a spoiler and rear visor for my is250, I believe you have to put double-sided tape on to stick 'em on to your car. Does anyone have suggestions on what kind of tape, because I do not want it flying off while I am driving. Thanks fellas!

eric_r_ho

iTrader: (9)

3M mounting tape, rated for 5lbs, red backing can be found ANYwhurrrr.

xxjtp1xx

iTrader: (4)

Thank you thank you [:

RA030724

iTrader: (1)

Actually, I think this is the version of the 3M tape you'll need. I get it at any auto parts store or auto paint supply store. See attached pdf.

javyLSU

iTrader: (21)

The tape below is what I've always used, available at a Wal-Mart or Auto Zone near you - although any one of the tapes above will work too.



Javier

RYLITT

I used that^^ on my last car to hold my front lip on before I got it custom molded.

joeker

iTrader: (8)

go to autozone.. they have an automotive 3m double sided tape.. i think its the same one as javyLSU has..

Phil888

iTrader: (1)

^^^Yes sir they're all practically the same. Remember to get some adhensive cleaner to wipe down before applying anything. DO it once do it right!! GL

JVT

IMO The 3M tape is not the best, the corner of the spoiler does not stick to well. If you do not plan to swap or remove your rear spoiler, I highly suggest you use epoxy instead.

Phil888

iTrader: (1)

Their will always be better products out their, but 3M tapes are done the job for my car. My wald kit, visors, trunk spoiler and roof spoiler all used 3M tape and its holding up hella good

Maxx250awd

Initial G

iTrader: (38)

I would suggest 3M tape that holds up to 5lbs (red back). Used it myself and it works wonders. You can get it from Staples or Office Max.