Last edit by: IB Advertising
See related guides and technical advice from our community experts:
Browse all: Interior
- How to Install a Navigation System
Step by step instructions for do-it-yourself repairs
Browse all: Interior
FlyAudio In-Dash Multimedia GPS Navigation System for Lexus IS250/350
#664
You mean firmware-wise? This is a good source from the source (ahem): http://flyaudio.us/forum/latest
#665
Ipod integration
I have a flyauido system and i see that some cars have a right button cluster on the steering wheel that has more options than just display what do those do and does it do anything for the flyaudio system if so where do i get one
#666
Javier
#670
When I go in to reverse, the backup camera says "TIP: check video signal" or some such. It was working fine a few days ago, and my car has been sitting around in the garage for two days and so I doubt a connection got loose.
Any ideas?
Any ideas?
#671
for those who are experiencing lag on load time on IGo8 maps and the clock being off please try the following method.
Go to Menu->setup->next->turn off "COLD START GPS". (the unit menu not the gps)
I did it and everything is working fine now.
hope this helps.
Go to Menu->setup->next->turn off "COLD START GPS". (the unit menu not the gps)
I did it and everything is working fine now.
hope this helps.
#672
Hey all. Does anyone know if Flyaudio has any plans to incorporate a VGA in instead of the low quality composite video in only? Reason I ask is for those who wish to add a CarPC. Since the whole Flyaudio system is based off Windows CE and in of itself is a CarPC, wondering if any plans to add the input possibility or software to allow internet?
#673
Hey all. Does anyone know if Flyaudio has any plans to incorporate a VGA in instead of the low quality composite video in only? Reason I ask is for those who wish to add a CarPC. Since the whole Flyaudio system is based off Windows CE and in of itself is a CarPC, wondering if any plans to add the input possibility or software to allow internet?
#674
it is persisting since the week end? Do you recommend I take apart the trunk and check teh connections? Or is there a way to force the software to "reboot"?
#675
I would check the connection 1st. Make sure to check the video connection, but also the wiring, to make sure that the camera is getting enough power. Did you solder the wires or just splice and connect?