Will those wheels fit? START HERE.
10-15-10, 10:59 PM
#1636
Driver School Candidate
Join Date: Oct 2010
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Haha I'd like to! Our roads are of greatly varying quality out here, so I'd prefer to keep them tucked a little bit, and also keep the option of lowering with some F-Sport springs in the future if it tickles my fancy....
I'm wondering now if it's going to rub on the fender liner or hit the strut in the rear?
I'm wondering now if it's going to rub on the fender liner or hit the strut in the rear?
10-19-10, 10:29 AM
#1639
Will this offset fit an Is250
20x9 +25 Hi Disk 5x114.3
20x10.5 +20 Mid Disk 5x114.3
And if not, what modifications need to be done? Thank you guys for the help in advance.
20x9 +25 Hi Disk 5x114.3
20x10.5 +20 Mid Disk 5x114.3
And if not, what modifications need to be done? Thank you guys for the help in advance.
10-19-10, 10:35 PM
#1641
Lexus Test Driver
iTrader: (3)
Join Date: May 2007
Location: CA
Posts: 954
Likes: 0
Received 0 Likes
on
0 Posts
I have 20X9 +20 stock fender with 225/30, very low, minimum rubbing, but be careful on incline/declines. And I have 20X10.5 +17 235/35, not as low as fronts, but pulled fenders.
10-19-10, 10:58 PM
#1645
heres my question lets see if i can word it right: i am currently running on work vsxx 20x9, 225/35 +36 front and 20x10 255/35 +32 rear. Im dropped on bcrs. i currently only have minor rub in the front on the tab and bolt that hold the bumper to the fender after i did some mods to it. my fenders are pulled and rolled/shaved?. i am tucking a lil bit but i want to get a fuller flusher look so to speak, so i was wondering if i went a little wider on the tires 235/35 and 275/35 front and rear respectively, will that fill it out some(make it stick out a little more if you will) or will i need to use spacers? or will it just rub way too much?
10-19-10, 11:05 PM
#1646
I currently have 18x10 +33 fronts and 18x11 +40 rears
but are wondering if I could change the outer lip for a wider
lip by installing a bigger lip to increasing it. SO my question
is what is the widest I can go without doing major fender work except
for rolling them? hehe
thnx,
toHn
but are wondering if I could change the outer lip for a wider
lip by installing a bigger lip to increasing it. SO my question
is what is the widest I can go without doing major fender work except
for rolling them? hehe
thnx,
toHn
