New dent in is250
#16
Driver School Candidate
Thread Starter
Join Date: Dec 2009
Location: Ca
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Thanks! Now for the clear bra! Sucks not being able to drive it on highways till the paint cures and I can get the clear bra on. Anyways, I get it done on Saturday so I'll post more pics of the clear bra after it gets installed. I'm going with venture shield. I have it on my other car and it's holding pretty well.
Last edited by Rizon25; 08-17-10 at 01:59 PM.
#21
Driver School Candidate
Thread Starter
Join Date: Dec 2009
Location: Ca
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
#22
Driver School Candidate
Thread Starter
Join Date: Dec 2009
Location: Ca
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Yeah, the clear bra guy told me if it gets put on too early, the paint will come off with the clear bra when you try to remove it. Ya, I'm going to wait till it cures.
#23
Driver School Candidate
Thread Starter
Join Date: Dec 2009
Location: Ca
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
I had the clear bra put on my headlights, fogs, mirrors, hood, and fender. I'm going to have to wait on the bumper until the paint cures. I aimed my halogen lights directly at the car so that you can see where the clear bra is. When the car is outside, it's hard to see it at all.
The clear bra I used is from venture shield whom 3m bought out. It's pretty thick. I think it's the best clear bra out there. Also, the clear bra was precut using xpel. I have the same thing on my Lancer for about 6 months now and the front looks as good as new, and no yellowing. I just use Plexus to clean the clear bra after each wash.
The clear bra I used is from venture shield whom 3m bought out. It's pretty thick. I think it's the best clear bra out there. Also, the clear bra was precut using xpel. I have the same thing on my Lancer for about 6 months now and the front looks as good as new, and no yellowing. I just use Plexus to clean the clear bra after each wash.
#24
Driver School Candidate
Join Date: Aug 2010
Location: NY
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Got my car back and had all the dents/scratches taken out as well as the license plate holes. Unfortunately, the dent couldn't be taken out by pdr method. Had to go the more expensive traditional route. I'm happy though. Got it done at Michael's Auto body and paint in Fullerton, CA.
Thread
Thread Starter
Forum
Replies
Last Post