Can you turn off Traction & Stability control completely
#1
Can you turn off Traction & Stability control completely
Just wanted to know if the Traction and Stability controls in the 2010 Lexus IS rear wheel drive models, be completely turned off ?
Will appreciate valuable inputs. Thanks.
Will appreciate valuable inputs. Thanks.
#2
To my knowledge it should be the same for 07+.
While stopped press and hold the traction control button for about 5 seconds until both traction lights light up (the trac and VSC or whatever it's called)
It's now off. It will turn back on if you press the button or turn off the car.
While stopped press and hold the traction control button for about 5 seconds until both traction lights light up (the trac and VSC or whatever it's called)
It's now off. It will turn back on if you press the button or turn off the car.
#3
To my knowledge it should be the same for 07+.
While stopped press and hold the traction control button for about 5 seconds until both traction lights light up (the trac and VSC or whatever it's called)
It's now off. It will turn back on if you press the button or turn off the car.
While stopped press and hold the traction control button for about 5 seconds until both traction lights light up (the trac and VSC or whatever it's called)
It's now off. It will turn back on if you press the button or turn off the car.
Does it mean that one of the 2(Traction/Stability) will be on although it shows itself as off ?
#5
If you press and release the button, traction control turns off, VSC is still on, and when your speed increases, traction control will turn itself back on. If you press and hold it for 3 seconds, traction and stability control (VSC) turn off. At this point there is no interference, and it will not re-enable itself. It is totally off at this point.
EDIT: Until you turn the car off, then it resets.
Jeff
EDIT: Until you turn the car off, then it resets.
Jeff
Last edited by Jeff Lange; 04-09-11 at 11:22 AM.
#6
If you don't mind me asking , (it's Off topic) did you have a tire noise issue when you purchased your vehicle ?
If so how did you remedy it ?
Last edited by stanjohn12; 04-09-11 at 09:55 AM. Reason: Needed to ask one more question
#7
If you press and release the button, traction control turns off, VSC is still on, and when your speed increases, traction control will turn itself back on. If you press and hold it for 3 seconds, traction and stability control (VSC) turn off. At this point there is no interference, and it will not re-enable itself. It is totally off at this point.
Jeff
Jeff
Thread
Thread Starter
Forum
Replies
Last Post
Eedo123
IS F (2008-2014)
9
03-19-16 10:11 PM
SC430Sam
SC430 - 2nd Gen (2001-2010)
18
03-23-08 12:01 AM