Pic of your 2IS - RIGHT NOW ! take 2
#6826
Driver School Candidate
#6828
Intermediate
Washed, clayed and coated with Turtle Wax Seal & Shine. Ready to start 2020 with a clean slate
The following users liked this post:
Boomin (01-04-20)
#6829
Intermediate
The following 2 users liked this post by lady2is:
bbaugher47 (01-04-20),
marcsis250 (02-04-20)
#6831
Lady2is, did you cut the OEM bumper before putting on the gfx rear? Or just tape it on? I’ve been nervous about installing mine. Been sitting on it for over two years.
#6832
hello, i initially tried taping it on w.o cutting the bumper, but there were noticeable gaps where the lip curves above the exhaust hole. I ended up cutting into the OEM bumper and removing the tabs that are taped onto the lip in order to get flush fitment. I read that some members were able to successfully install the lip w.o cutting the bumper, so I would try that before chopping it up. (:
Last edited by lady2is; 01-04-20 at 11:12 AM.
The following users liked this post:
bbaugher47 (01-04-20)
#6833
Intermediate
#6835
Intermediate
Upgrade time! 3IS front bumper conversion on the way! 🥳
As much as I like the factory front with the addition of the front lip, I decided that it's time for a change. The 3IS conversion will take a couple of months on sea-freight to reach me in New Zealand + the time to get it painted, so it will be a while before I can post photos of it on, but this photoshop I did of the current look vs conversion gives me something to look forward to
As much as I like the factory front with the addition of the front lip, I decided that it's time for a change. The 3IS conversion will take a couple of months on sea-freight to reach me in New Zealand + the time to get it painted, so it will be a while before I can post photos of it on, but this photoshop I did of the current look vs conversion gives me something to look forward to
The following users liked this post:
NinjaSocks (01-27-20)
The following users liked this post:
NinjaSocks (01-29-20)
The following 2 users liked this post by 2013FSport:
DownUnder (02-01-20),
NinjaSocks (01-29-20)
#6839
Intermediate
Speaking of which, I upgraded from the smaller GFX spoiler to this Wald style ducktail today, in order to match the rear better as it looked a bit too small in comparison to the lower lip and roof spoiler I added afterwards.
The badge also had an upgrade to a fully enclosed gloss black version, which matches my radar cruise control badge on the front grille. Takes a bit of getting used to but I'm liking the thicc look
The following users liked this post:
primavera (02-01-20)
#6840
Intermediate
The following 2 users liked this post by DownUnder:
2013FSport (02-12-20),
primavera (02-02-20)