Pic of your 2IS - RIGHT NOW ! take 2
#7216
Intermediate
You're very welcome. The replacement emblem is held on with double sided tape so no prongs to worry about. I recommend putting a couple of tiny squares of electrical tape on the old holes in the trunk where the prongs used to go as it will stop any water getting in.
The following users liked this post:
JuiceWRLD (10-19-22)
#7222
Intermediate
"And then there were four"
I've gotta stop buying these cars.....
I've gotta stop buying these cars.....
#7223
Instructor
Lol, where's the red ISF?
#7227
19s fitted yesterday. Fitment is almost perfect. Can get the rear wheels out by another 5mm to be almost flush. The fronts are crazy and I'm very happy with them
19 x 9.5 squared (+35). Added a 10mm spacer to the front so the spokes clear the calipers.
F: 235/35
R: 265/35
Rolled the rear guards as I wasn't sure the 265 would fit but there's quite a bit of room for either a 275/30 tire or throwing on a spacer to push out the 265.
There was some rubbing in the rear but that was because the last time I worked on the car to remove my rear bumper, I didn't put back the liner properly. That is no longer an issue
Special thanks to member DownUnder for the help and guidance along the way. I couldn't have done it without him.
19 x 9.5 squared (+35). Added a 10mm spacer to the front so the spokes clear the calipers.
F: 235/35
R: 265/35
Rolled the rear guards as I wasn't sure the 265 would fit but there's quite a bit of room for either a 275/30 tire or throwing on a spacer to push out the 265.
There was some rubbing in the rear but that was because the last time I worked on the car to remove my rear bumper, I didn't put back the liner properly. That is no longer an issue
Special thanks to member DownUnder for the help and guidance along the way. I couldn't have done it without him.
Last edited by L350XIS; 11-26-22 at 05:03 PM. Reason: Add spacing between the images
The following 3 users liked this post by L350XIS:
The following users liked this post:
L350XIS (11-27-22)
#7229
Instructor
L350XIS Lookin' good, nice wheels, nice stance!
#7230
Thank you. Its not yet perfect.
I can push the rear out another 5mm then it should closely match the front.
Wheel shop damaged (bent) one of my 5mm spacers so I have to buy another set.
No idea how they managed to do that
I can push the rear out another 5mm then it should closely match the front.
Wheel shop damaged (bent) one of my 5mm spacers so I have to buy another set.
No idea how they managed to do that