Wiper Blade Winter/Snow Mode Help!
#1
Wiper Blade Winter/Snow Mode Help!
Hi guys - I recently got my windshield replaced and noticed my passenger side wiper blade doesn’t go all the way down now. Did a little reading and some posts say it might be in winter/ snow mode, is this the case for me? I have looked everywhere in the owner’s manual and can’t find where to correct this issue.
Help! Thanks!
Help! Thanks!
#2
No such thing on the IS. The person who put your windshield on just didn't put your passenger side wiper back in the right position. It's an easy fix - just remove the nut that holds the wiper arm on, pull it off the splined post, put it back on the splined post in the correct position and replace the nut.
Last edited by Bichon; 03-20-15 at 10:26 AM.
#4
4. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH
(a) Operate the wiper, and stop the windshield wiper motor at the automatic stop position.
(b) Clean the wiper arm serrations.
(c) Clean the wiper pivot serrations with a wire brush (when reinstalling).
(d) Install the front wiper arm and blade assembly LH with
the nut at the position as shown in the illustration.
Torque:
22 N·m {224 kgf·cm, 16ft·lbf}
HINT:
Hold the arm hinge by hand to fasten the nut.
AREA MEASUREMENT
A 15 to 30 mm (0.59 to 1.18 in.)
B Approx. 40 mm (1.57 in.)
(a) Operate the wiper, and stop the windshield wiper motor at the automatic stop position.
(b) Clean the wiper arm serrations.
(c) Clean the wiper pivot serrations with a wire brush (when reinstalling).
(d) Install the front wiper arm and blade assembly LH with
the nut at the position as shown in the illustration.
Torque:
22 N·m {224 kgf·cm, 16ft·lbf}
HINT:
Hold the arm hinge by hand to fasten the nut.
AREA MEASUREMENT
A 15 to 30 mm (0.59 to 1.18 in.)
B Approx. 40 mm (1.57 in.)
Thread
Thread Starter
Forum
Replies
Last Post
carid
Automotive Care & Detailing
4
09-11-16 11:40 PM