F-Sport Short Shift Kit for 250 6MT
#31
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
This part is discontinued and no longer produced with no stock left. The only ones you can find are used.
It would be pretty easy to have the part made to be honest, however the tricky part is the extended rubber boot. If someone could mold that, I could have these (or even better) quickshifter kits made again.
I may look into having that done at some point, I'm sure some 3D printing place can do a flexible material for the boot or similar. As I said, getting the metal pieces done up would be no problem at all.
Jeff
It would be pretty easy to have the part made to be honest, however the tricky part is the extended rubber boot. If someone could mold that, I could have these (or even better) quickshifter kits made again.
I may look into having that done at some point, I'm sure some 3D printing place can do a flexible material for the boot or similar. As I said, getting the metal pieces done up would be no problem at all.
Jeff
![Wink](https://www.clublexus.com/forums/images/smilies/wink.gif)
#32
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
Correct, the original F-Sport shifter increased the length below the fulcrum by 25mm. I would probably do 30mm if I was doing it.
I also recently found out that the 3D printer I have access to is able to print flexible rubber parts. I will be investigating further...
Jeff
I also recently found out that the 3D printer I have access to is able to print flexible rubber parts. I will be investigating further...
Jeff
Thread
Thread Starter
Forum
Replies
Last Post
Individual
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
17
08-15-14 05:23 PM
Wunko
IS - 2nd Gen (2006-2013)
9
12-03-12 06:46 PM