DW97

New here... I just replaced the front passenger side wheel hub assembly on an 06 IS250. Everything was put back the way it was and torqued to specs with exception of the dust shield. I had already put everything back on when I realized I forgot this. When I started the car to drive it the ABS light was on along with the Check VSC and Check 4WD. On top of this, the car now grinds when turning left. I cant imagine the dust shield not being on could cause this could it? Could this be something I possibly didn't do correctly or could it be a bad CV boot or even a bad hub assembly on the driver side? Looking for thoughts.

MikeFig82

iTrader: (13)

I would remove the tire and lift the car up and spin the hub. To see where it is rubbing. Did you buy an OEM hub? Could be the hub you got is no good.

primavera

Wheel bearings are Left and Right side, make sure you installed the correct one.
https://www.clublexus.com/forums/is-...ac-on-now.html

Gville350

iTrader: (10)

Wouldn't the brake shield act as a thin spacer thus changing the alignment of all of the braking components? In my head, without the shield on there, it spaces the caliper closer inside the well causing the rotor to "drag" on the inner brake pad. Never had to replace any of my hubs, so I'm just thinking out loud here.