Any specific way to fix this issue? Seems like bumper went atop a curb and when it reversed it pulled this bottom part outward. Tried to somewhat bend it back inwards but wouldn’t budge.

 

Heat gun the area you'll need to bend to help make it pliable. If you don't have one, a hair drier will work too.

 

Alright, I’ll give it a shot. Would it be fine to just leave the bumper or would I have to take it off?

 

Leave everything as is and use your heat gun or blower and bend the plastic. Once bent, tape it up so it stays and remove the tape a few days later. Good luck.

 

A few years ago a guy in an old beat up van repaired a rear bumper cover that was crushed in on my 2006 Camry. He used nothing but a heat gun and some bondo. A body shop wanted to charge me $1400 for a new bumper cover plus labor and paint. This guy's work was so perfect it looked brand new, all for $200. The only issue was the paint only lasted about 2 years before it began to fade. Luckily someone rear ended my daughter who was driving it in 2019 and we ended up with a new bumper cover and paint. As everyone mentioned, heat gun should do the trick

 

Don't hear that too often. LOL! But I know what you meant.

 

Haha I could have worded that better