06 IS250 screen not working after replacing digitizer
#1
2nd gear
Thread Starter
Join Date: Jan 2023
Location: New Mexico
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
06 IS250 screen not working after replacing digitizer
My touch screen recently went out on my 2006 is250 and from what forums said the problem was the digitizer. got a new digitizer and installed into the nav unit and all went good, all the pins were connected on the ribbon connectors, and everything is plugged in. put it all back together and plugged everything back into the radio and nav unit. then when i power it on the screen remains black and does not turn on. the security still light blinks and hazards work. there’s no beep when pressing any of the buttons on the nav unit. any ideas? i have un plugged and replugged everything over and over , even took the nav unit apart again and made sure everything was connected but had so luck.
The following users liked this post:
Protholl (01-10-23)
#3
2nd gear
Thread Starter
Join Date: Jan 2023
Location: New Mexico
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post