CF Vinyl On Center Console & Interior Trim
#31
#32
Looks great. The plastic scratches so easily, this is the perfect solution. I didn't know you could remove the whole panel! Also, anyone trying to attempt this, also take a look at the 4D carbon vinyl, I was very surprised as I have seen and tried both 3M dinoc and 4D.
#33
Looks great. The plastic scratches so easily, this is the perfect solution. I didn't know you could remove the whole panel! Also, anyone trying to attempt this, also take a look at the 4D carbon vinyl, I was very surprised as I have seen and tried both 3M dinoc and 4D.
#35
Thanks A little advice for people who are going to do this!
When wrapping the center console panel, make sure to wrap all the way down at the seam where front panel and rear panel touch, because the rear panel can only be installed from straight up, cannot be angled, if you dont wrap all the way down, the front panel will push the vinyl up and ruin it :/ although not SUPER noticeable, but its preventable
When wrapping the center console panel, make sure to wrap all the way down at the seam where front panel and rear panel touch, because the rear panel can only be installed from straight up, cannot be angled, if you dont wrap all the way down, the front panel will push the vinyl up and ruin it :/ although not SUPER noticeable, but its preventable
#37
Thread
Thread Starter
Forum
Replies
Last Post
rschaer
IS - 2nd Gen (2006-2013)
9
10-25-14 08:45 PM
vboi4life
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
1
09-25-12 12:39 AM
timeToy
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
21
09-21-09 09:27 AM