How to remove B pillar trim?
#1
Driver School Candidate
Thread Starter
How to remove B pillar trim?
Hey, I'm installing a two channel dash cam on my '16 IS350, I was able to get the A pillar and C pillar trim off no problem, but I can't get the B pillar trim off to stuff the wire behind it. There's also not enough of a gap to just jam the wire in. Does anyone know how to get this trim piece off easily? I've attached a picture of the issue:
Thanks!
Thanks!
#2
Lexus Test Driver
Join Date: Feb 2017
Location: Richmond Hill, Ontario, Canada
Posts: 6,260
Received 1,738 Likes
on
1,371 Posts
Here ya go...see attached.
ONLY perform Steps 7, 10, 11, and 12.
Good luck!
ONLY perform Steps 7, 10, 11, and 12.
Good luck!
The following users liked this post:
franco92 (03-14-23)
#3
Driver School Candidate
Thread Starter
Thank you so much, that's exactly what I needed! Got the B pillar off in about 5 minutes. Who knew there were screws involved when all the other trim just pops off.
#4
Sorry to hijack this thread, but does anyone knows how to remove the wheel arch inner fender? The piece just above the wheels.
#5
Lexus Test Driver
Join Date: Feb 2017
Location: Richmond Hill, Ontario, Canada
Posts: 6,260
Received 1,738 Likes
on
1,371 Posts
#6
#7
Lexus Test Driver
Join Date: Feb 2017
Location: Richmond Hill, Ontario, Canada
Posts: 6,260
Received 1,738 Likes
on
1,371 Posts
I had a look, but unfortunately there are no explicit instructions on removing the fender liner.
From removing various fender liners myself, basically remove the wheel, start at one end of the liner and remove every bolt, clip, or plug that goes through it.
Once you've made your way to the other end of the liner, then you will be able to just pull it out.
There will be a fastener or two under the vehicle at each end of the liner.
From removing various fender liners myself, basically remove the wheel, start at one end of the liner and remove every bolt, clip, or plug that goes through it.
Once you've made your way to the other end of the liner, then you will be able to just pull it out.
There will be a fastener or two under the vehicle at each end of the liner.
The following users liked this post:
zhifan1 (07-18-19)
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post