Re-skin center console lid
#1
Driver School Candidate
Thread Starter
Re-skin center console lid
I had a rip in the center console lid so I purchased a new skin on eBay(pic attached).
I used Gorilla glue spray adhesive.
The end result is far from perfect. It was the end result of extreme frustration. It’s a super tight fit, and you need the adhesive for when you get the fit right, but up until that point the adhesive just makes a huge pain in the ***.
I literally finished 5 min ago so I do feel like it’ll settle and look a little better. But either way I’m much happier with this than what I had before.
I used Gorilla glue spray adhesive.
The end result is far from perfect. It was the end result of extreme frustration. It’s a super tight fit, and you need the adhesive for when you get the fit right, but up until that point the adhesive just makes a huge pain in the ***.
I literally finished 5 min ago so I do feel like it’ll settle and look a little better. But either way I’m much happier with this than what I had before.
The following users liked this post:
Rhydg1 (05-21-20)
Thread
Thread Starter
Forum
Replies
Last Post
Need4Speed
Club Lexus Vendor Marketplace
2
10-18-19 04:55 AM
flipside909
LFA Model (2012)
9
10-14-09 09:00 PM