IS - 3rd Gen (2014-present) Discussion about the 2014+ model IS models

reduce engine power

Thread Tools
 
Search this Thread
 
Old 10-10-21 | 06:13 PM
  #1  
alzaabi's Avatar
alzaabi
Thread Starter
Driver School Candidate
 
Joined: Oct 2021
Posts: 5
Likes: 0
From: oman
Angry reduce engine power

moorning ,


since month i face that issue " reduce engine power " and i went to check and i found : charge air cooler temperature sensor !

the power is reduce too much and turbo also reduce if i bush from zero !

also i search about this sensor but i not found any thing about it !


Old 10-11-21 | 05:51 PM
  #2  
Sasnuke's Avatar
Sasnuke
Lexus Test Driver
 
Joined: Feb 2017
Posts: 6,260
Likes: 1,738
From: Richmond Hill, Ontario, Canada
Default

Welcome to the forum!

Below is a pic of where the sensor is located. I suggest first confirm it is plugged in and the connector/wires are not damaged.

The following users liked this post:
arentz07 (10-12-21)
Old 10-14-21 | 04:47 AM
  #3  
alzaabi's Avatar
alzaabi
Thread Starter
Driver School Candidate
 
Joined: Oct 2021
Posts: 5
Likes: 0
From: oman
Smile

Originally Posted by Sasnuke
Welcome to the forum!

Below is a pic of where the sensor is located. I suggest first confirm it is plugged in and the connector/wires are not damaged.
thank you mr.Sasuke for your reply

i disconnect and i see the turbo gauge off and the pointer in red zone " No safety "
also check engine not working during i disconnect this sensor

i think i have issue in car electricity
Old 10-14-21 | 05:40 AM
  #4  
Sasnuke's Avatar
Sasnuke
Lexus Test Driver
 
Joined: Feb 2017
Posts: 6,260
Likes: 1,738
From: Richmond Hill, Ontario, Canada
Default

If you disconnected the sensor and the car reacted by turning the turbo gauge off and the pointer went into the red zone "No Safety", then I suspect the car's electrical system is fine.
The check engine light not coming on might be okay...sometimes the computer has to see the error on at least two drive cycles before it triggers the light.
Without further testing that would require a Techstream, I would suggest replacing the sensor.
Old 10-14-21 | 05:44 AM
  #5  
alzaabi's Avatar
alzaabi
Thread Starter
Driver School Candidate
 
Joined: Oct 2021
Posts: 5
Likes: 0
From: oman
Default

first i will replace sensor it's not difficult

i hope the issue from sensor

regards,
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
L3xusGX
GX - 2nd Gen (2010-2023)
3
05-06-21 05:37 AM
JesLet
Maintenance
5
11-13-13 08:02 AM
turbo80
LS - 1st and 2nd Gen (1990-2000)
1
08-17-11 12:24 PM
Jeff92se
Hybrid Technology
1
02-18-11 06:24 AM
SteVTEC
Car Chat
7
04-16-06 07:57 AM




All times are GMT -7. The time now is 02:53 PM.