Any tips/tricks for installing GTHaus valved exhaust?
#1
Any tips/tricks for installing GTHaus valved exhaust?
Plan on doing the install Friday. I subscribed to https://www.youtube.com/@specONE Rodney and watched some of his install video, but I wanted different perspectives.
I assume that since this is built for the IS 500, everything is the correct fitment-wise, and the vacuum tubes/wire harness is the right length? I'm really curious on how people have everything run. Maybe it will be obvious once the car is on a lift.
I have two OEM exhaust gaskets and six torque solutions 12mm exhaust hangers. Is there anything else I need?
I assume that since this is built for the IS 500, everything is the correct fitment-wise, and the vacuum tubes/wire harness is the right length? I'm really curious on how people have everything run. Maybe it will be obvious once the car is on a lift.
I have two OEM exhaust gaskets and six torque solutions 12mm exhaust hangers. Is there anything else I need?
#2
Can’t comment on the vacuum line as I have valveless but just a general installation tip. A portion of the midpipe was touching the sheet metal around the driveshaft. You may need to push the metal out of the way slightly to prevent rattling.
The following users liked this post:
Lucci (04-25-23)
Thread
Thread Starter
Forum
Replies
Last Post