Finally put my Lexon lip on my Obsidian IS-F
#31
Lexus Champion
Looks awesome Nic!! Where did you end up mounting it?
You will have to take steep inclines at an angle but you should be fine until you lower the car I have a tendency to take up the entire entrance/exit ramp at certain places just so I don't scrape too bad. The car is looking great! Are you taking the winter wheels and tires off soon?
You will have to take steep inclines at an angle but you should be fine until you lower the car I have a tendency to take up the entire entrance/exit ramp at certain places just so I don't scrape too bad. The car is looking great! Are you taking the winter wheels and tires off soon?
#32
Lexus Test Driver
Thread Starter
I ended up mounting it in my driveway. I put the car on ramps where it would give me access to the bottom screws that hold the front bumper cover in place. I was able to put the lip on temporarily to drill 6 additional holes in the bottom of the car. Once the holes were drilled, I took the car off the ramp because it would not clear the ramp with the lip on. Once the car was down, I just used the 6 screws, washers and bolts that came with the lip and affixed it to the car. Would have been easier if I had someone to help support one end of the lip however I did it myself.
#37
Lexus Test Driver
Thread Starter
#41
Lexus Test Driver
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
Evil Teo
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
8
06-23-13 11:30 PM
JDMes
SC- 1st Gen (1992-2000)
42
11-27-08 03:08 PM