So how is it going Figs? I would like to know the weight of the stock seats vs. the aftermarket seats and approximate cost.

 

I love your radar set up. Can you send me a pm on the mount or what you did to make it so slick. I have been looking for a slick mount and yours is by far the best i have seen.

 

Still chasing a few other things. Will do seats here pretty soon.

 

Zaps here is the link, I have the same one.

http://store.blendmount.com/is-f-c506.aspx

 

Damn thats a pretty expensive mount. But it is nice as could be. Did you also get the hard wire cable?

 

My V1 came with a hardwire set up and I just tapped into one of the hot wires by the sunroof. Actually stumbled across the DIY in the forum somewhere.

 

i got my mount from MICHAEL PERONEK, MIKE3348@ROADRUNNER.COM email him, mine was like $30 or $40? i think. I bot it a couple years back no complaints.

BTW sorry to go OT.
Bump for FIGS on the resistor.

 

I posted the R value previously. According to Status Seats 3.3V is typical so 1.5W should suffice on a rating.
Mike

 

Any update on defeating the warning light? I'm looking at having a seat for events. A helmet makes me just a bit too tall.

 

Old Thread. But was any update ever made FIGS?

 

Yes, it works. we have several customers using it.
Mike

 

 

link to your website on the bypass plug?

 

I am starting to see quite a few aftermarket seats on this forum.

Please post your seat and experience. I need side bolster support on track due to blowing out three lower disks, but I also can’t sit bolt upright for the same reason. A seat with lumbar support helps a lot. I sat in some Tillets, and they were very supportive and ergonomic, but come at an excessive price. All input is appreciated.

 

I just got my seats (driver & passenger) Racetech RT1000 with Sparco bases and sliders. I like the seat and it's very comfortable. The only complaint is Sparco base has limited adjustment. I just ordered Planted base for replacement.