When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Had them installed by Tommy yesterday. I was thinking about clear bra before having them installed, but I was itching to get them on and see the output for myself. It is definitely an upgrade. Do you think a film would suffice, or would the housing have to be removed? The only problem is, my fogs are now brighter than my headlights. Changes to come...
Slap on film will work too... I did DIY film on my own, before installing.
Slap on film will work too... I did DIY film on my own, before installing.
Time for the new headlamp housings .
~ Joe Z
That's what Tommy said too (about the headlights). I was thinking a lighter Optic Blue than the one Aerotect offered, but CHP nabbed me for that with the original fog lamp.
Very nice, did you also change your Daylight driving lights? (first beam?)
Well the DRL's on the '08s are the high beams just on at low power. I've programmed them to be off and I switched out the parking light that is located in the same area as the high beam bulb.
I have yet to install my set. Did you guys have to adjust them after installation? Are they somewhat pre-adjusted already or you adjusted the ***** before installation? Thanks!
I have yet to install my set. Did you guys have to adjust them after installation? Are they somewhat pre-adjusted already or you adjusted the ***** before installation? Thanks!
Had to adjust mine quite a bit. If I recall correctly they were too low from the start.
So I installed the driver's side first and without adjusting, it looked like it lined up with the stock one (1st picture). I also did not adjust the passenger side and both lined up. Drove and see how they work and they seem low. Correct me if I'm wrong, the round plastic cap on the fender liner is to access the adjustment ****? I really don't want to unscrew the liner screws again. Oh, both also fogged up on the bottom part but they are going away (2nd picture)
Edit: The caps are right below the fog lights so I'm confirming that we can adjust them through those holes.