K&N Cold Air Intake Follow Up Runs ! Myth debunked !
#17
Lead Lap
I run at Bradenton Motorsports from time to time. It's not going to make a big difference in your DA calculations, but the track elevation is actually 59.1 feet above sea level.
Great runs though! I didn't know the IS F could run that quickly. 1.9 60'? Is that on stock tires? That's part of the reason why your times are so good. If you are on stock tires then I'm impressed. Even in the RC F it's hard to cut 1.9 60's on the stock tires and they are wider and the car is heavier.
Great runs though! I didn't know the IS F could run that quickly. 1.9 60'? Is that on stock tires? That's part of the reason why your times are so good. If you are on stock tires then I'm impressed. Even in the RC F it's hard to cut 1.9 60's on the stock tires and they are wider and the car is heavier.
#21
Driver
Thread Starter
Join Date: Oct 2016
Location: Florida
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
I do not see how you could drop a half second auto vs. manual mode.
So far all my best times have been full auto / Sport mode / traction control disabled, foot brake to 1,900 rpm's.
#22
Driver
Thread Starter
Join Date: Oct 2016
Location: Florida
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
I already posted them in a previous thread. The one posted in this thread were new bests yesterday in the two different modes.
#23
Driver
Thread Starter
Join Date: Oct 2016
Location: Florida
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
I run at Bradenton Motorsports from time to time. It's not going to make a big difference in your DA calculations, but the track elevation is actually 59.1 feet above sea level.
Great runs though! I didn't know the IS F could run that quickly. 1.9 60'? Is that on stock tires? That's part of the reason why your times are so good. If you are on stock tires then I'm impressed. Even in the RC F it's hard to cut 1.9 60's on the stock tires and they are wider and the car is heavier.
Great runs though! I didn't know the IS F could run that quickly. 1.9 60'? Is that on stock tires? That's part of the reason why your times are so good. If you are on stock tires then I'm impressed. Even in the RC F it's hard to cut 1.9 60's on the stock tires and they are wider and the car is heavier.
According to the county info I found for BMP it says 19.1, but yeah the awesome weather doesn't make a big a difference as most would think. Now on a forced induction car, heck yes.
Thanks, I am surprised too on the 60 ft times as well, a few more runs yesterday I bet I could have got a 1.89. Stock tires that are about 3/4 worn out, actually getting two new rears late this week. Anything made up in the 60ft times is doubled on the big end. My race car has always been this way. When I got down to a 1.31 60 ft' times from 1.4's I dropped two tenths on the big end.
#24
Driver
Thread Starter
Join Date: Oct 2016
Location: Florida
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
I thought the same thing too for manual mode but I have now made seven hits at the track and the new best time has been on auto mode each trip. Unless my tach is off a few hundred and I am shifting beyond the peak power I do not get it either. However if you look at the slips I posted, the manual mode was slightly slower et but faster mph. This is because in auto mode the car shifts one more time at the 1,000 ft box on the track where as manual mode you can carry that gear all the way through.
#26
Lead Lap
According to the county info I found for BMP it says 19.1, but yeah the awesome weather doesn't make a big a difference as most would think. Now on a forced induction car, heck yes.
Thanks, I am surprised too on the 60 ft times as well, a few more runs yesterday I bet I could have got a 1.89. Stock tires that are about 3/4 worn out, actually getting two new rears late this week. Anything made up in the 60ft times is doubled on the big end. My race car has always been this way. When I got down to a 1.31 60 ft' times from 1.4's I dropped two tenths on the big end.
Thanks, I am surprised too on the 60 ft times as well, a few more runs yesterday I bet I could have got a 1.89. Stock tires that are about 3/4 worn out, actually getting two new rears late this week. Anything made up in the 60ft times is doubled on the big end. My race car has always been this way. When I got down to a 1.31 60 ft' times from 1.4's I dropped two tenths on the big end.
http://airdensityonline.com/track-fo...orsports_Park/
Yup, I've always found that .1 off of the 60' was .2 off of the ET. I've been into drag racing since the mid 90's, but I've never had an actual race car. My buddy had a 89 5.0 Mustang much like the one you mentioned in your OP. I was always into the Camaro myself. Especially when it got the LS1. I dragged it religiously at Gateway International near St. Louis. I haven't been able to get my RC F to the track yet. But I'll have to learn how to launch it. All of my previous cars had a manual tranny. This will be my first auto...
#27
Driver
Thread Starter
Join Date: Oct 2016
Location: Florida
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
Like I said, it's not a big deal. But here's the page you get to directly from the motorsports website, for future reference:
http://airdensityonline.com/track-fo...orsports_Park/
Yup, I've always found that .1 off of the 60' was .2 off of the ET. I've been into drag racing since the mid 90's, but I've never had an actual race car. My buddy had a 89 5.0 Mustang much like the one you mentioned in your OP. I was always into the Camaro myself. Especially when it got the LS1. I dragged it religiously at Gateway International near St. Louis. I haven't been able to get my RC F to the track yet. But I'll have to learn how to launch it. All of my previous cars had a manual tranny. This will be my first auto...
http://airdensityonline.com/track-fo...orsports_Park/
Yup, I've always found that .1 off of the 60' was .2 off of the ET. I've been into drag racing since the mid 90's, but I've never had an actual race car. My buddy had a 89 5.0 Mustang much like the one you mentioned in your OP. I was always into the Camaro myself. Especially when it got the LS1. I dragged it religiously at Gateway International near St. Louis. I haven't been able to get my RC F to the track yet. But I'll have to learn how to launch it. All of my previous cars had a manual tranny. This will be my first auto...
Cool thanks on the altitude. I just plugged it in to the software on my runs and it made a .007 difference. lol
Here is my Mustang that I have had since new ( 1990 ). This is a 1.31 60 ft in this video with mostly stock suspension but a lot of fine tuning.
#28
Lead Lap
It sounds awesome. I'll have to wait until I get off of work to watch the video though. The firewall here blocks Youtube.
But at 1.31 60' I'm fairly certain you're running slicks. If I had to guess I'd say Mickey Thompsons? Just a wild guess...
That beats anything I ever did for a 60'. My racing was more to see how mods effected my car. But I kept it street legal. I never ran slicks. I just went to test and tune night every week.
But at 1.31 60' I'm fairly certain you're running slicks. If I had to guess I'd say Mickey Thompsons? Just a wild guess...
That beats anything I ever did for a 60'. My racing was more to see how mods effected my car. But I kept it street legal. I never ran slicks. I just went to test and tune night every week.
#29
Driver
Thread Starter
Join Date: Oct 2016
Location: Florida
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
It sounds awesome. I'll have to wait until I get off of work to watch the video though. The firewall here blocks Youtube.
But at 1.31 60' I'm fairly certain you're running slicks. If I had to guess I'd say Mickey Thompsons? Just a wild guess...
That beats anything I ever did for a 60'. My racing was more to see how mods effected my car. But I kept it street legal. I never ran slicks. I just went to test and tune night every week.
But at 1.31 60' I'm fairly certain you're running slicks. If I had to guess I'd say Mickey Thompsons? Just a wild guess...
That beats anything I ever did for a 60'. My racing was more to see how mods effected my car. But I kept it street legal. I never ran slicks. I just went to test and tune night every week.
Its been a fun fun ride with it over the years with a few different set ups.
#30
Lead Lap
I'm hoping to cut 1.9's with my RC F. I believe that I could with it stock. The only problem is it will no longer be stock when I finally get the chance to try. I'm too busy with work right now. Work > Play.