What are the crossover points/slopes of stock pioneer amp?
#1
What are the crossover points/slopes of stock pioneer amp?
Going to add aftermarket amp using LLC on front speakers and sub.
Wondering if the signal is already being crossed over adequately or is a separate crossover required?
Thanx.
Ryan
Wondering if the signal is already being crossed over adequately or is a separate crossover required?
Thanx.
Ryan
#2
The amp for the sub incorporates an active low pass filter. I don't know what the slope is (probably 12 dB). The x-over frequency is approximately 100 Hz.
There isn't any filtering on the bass/mid as far as I can tell. The crossover uses the naturall rolloff at the low end of the bass/mids.
Stevie
There isn't any filtering on the bass/mid as far as I can tell. The crossover uses the naturall rolloff at the low end of the bass/mids.
Stevie
#3
Thanks.
Can anyone CONFIRM this?
I am thinking about running the front speaker output to something like and audio control eqx and then crossover to the front and rear outputs.
That is if the front output is full range.
R
Can anyone CONFIRM this?
I am thinking about running the front speaker output to something like and audio control eqx and then crossover to the front and rear outputs.
That is if the front output is full range.
R
Thread
Thread Starter
Forum
Replies
Last Post
Kurtis916
Lexus Audio, Video, Security & Electronics
2
04-28-15 02:58 PM
olddog
Lexus Audio, Video, Security & Electronics
3
03-26-08 04:11 PM
franczyk
Lexus Audio, Video, Security & Electronics
4
05-08-05 03:50 PM