1993 GS300 with GTE Supra engine, single turbo (NJ)
#22
hmm...interesting trade, PM me more specs.
also to update, the interior front seats will be replaced next week, I will be upgrading the fuel by replacing the factory pump with 2 new high flow pumps and modifying the bracket to accomodate those 2 pumps (I will take pix and post up the install). car will stay with 550cc injectors, As my plan was to only have about 500~550 rear wheel HP at 18 psi. if that gets tiring, then 720cc will be installed.
If anyone needs a fuel pump upgrade kit... PM me as I will be making a set-up for 2 pumps in tank, good to support 650 rwhp max or 900 with other changes. thanks all on the interest.
Henri / NJ
also to update, the interior front seats will be replaced next week, I will be upgrading the fuel by replacing the factory pump with 2 new high flow pumps and modifying the bracket to accomodate those 2 pumps (I will take pix and post up the install). car will stay with 550cc injectors, As my plan was to only have about 500~550 rear wheel HP at 18 psi. if that gets tiring, then 720cc will be installed.
If anyone needs a fuel pump upgrade kit... PM me as I will be making a set-up for 2 pumps in tank, good to support 650 rwhp max or 900 with other changes. thanks all on the interest.
Henri / NJ
#26
Hey Henri, Grant here.
I too can vouch for how good of a seller this guy is! Honestly bro, when you told me you were selling I didn't think it would be nearly this low priced! I'm shocked it hasn't sold yet.
Shooting you a pm with some info as well...
I too can vouch for how good of a seller this guy is! Honestly bro, when you told me you were selling I didn't think it would be nearly this low priced! I'm shocked it hasn't sold yet.
Shooting you a pm with some info as well...
#28
Engine / trans have 87k miles, both out of US spec Supra.
#29
interior pix added, received my new (used) seats ($500) early this week...
the Wideband is there for tuning purposes, so might see wiring, cables on pass. side floor.
deleted pix
the Wideband is there for tuning purposes, so might see wiring, cables on pass. side floor.
deleted pix
Last edited by GTEgs300; 11-19-06 at 08:52 PM.
#30
just an update ... car idles around 14.7 a/f and on boost (low =14psi) (high =18psi) stays within a perfect 11.0~11.5 a/f. I also replaced the turbine (hot) side to a smaller .68 AR housing, the previous .81 AR seemed to be a bit laggy.