Removing and replacing drivers seat
03-22-07, 10:50 PM
#1
Removing and replacing drivers seat
I found a unworn, nice looking drivers seat out of a wrecked 1993 LS400 and want to install it in my 1990 LS400. I have never removed and replaced a drivers seat before on a luxury car equipped with airbags and power seats and wonder if I will encounter any complications or difficulties when trying to swap the seats? Thanks for any advice or hints.
03-22-07, 11:32 PM
#2
no, its 4 bolts and a wiring harness or 2, thats it.
there may be a complication if ur LS doesnt have the memory seat option though, as iirc it was standard on the 93-94.
to get to the front bolts put the seat ALLL the way up and Back
to get to the rear bolts put the seat ALLL the way UP and Forward
its also prolly easier to take it out by putting the seat forwards and up and pulling the backrest max straight and then turning it somewhat sideways to wedge it out the front door.
there may be a complication if ur LS doesnt have the memory seat option though, as iirc it was standard on the 93-94.
to get to the front bolts put the seat ALLL the way up and Back
to get to the rear bolts put the seat ALLL the way UP and Forward
its also prolly easier to take it out by putting the seat forwards and up and pulling the backrest max straight and then turning it somewhat sideways to wedge it out the front door.
Thread
Thread Starter
Forum
Replies
Last Post
