1995 Lexus LS 400 - Loud Squealing... Engine Area
#16
Lexus Test Driver
iTrader: (1)
If it turns out to be the serpentine belt, you might as well change it to the Goodyear Gatorback belt. Cost about the same as OEM, if not $10 more, but the design is so much better. It's quieter and will resist cracking. I changed it on my car and the noise difference was audible. Then again, my belt was sort of squeaking from before.
I went to friggin Autozone of all places and got me a Goodyear Gatorback belt.
I am very pleased with the results, extremely quiet and squeaking is gone. Thanks for the tip bud.
#17
Driver School Candidate
Join Date: Apr 2007
Location: MA
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Right, because Toyota actually manufactures Belts and Motor Oil themselves...
it's called outsourcing, people. The lowest bidder wins. OEM isn't always the answer.
Gates or Goodyear Gatorback is the obvious choice. Dayco too, but I personally have never had good luck with them.
Not to mention that oil is so much more complex than a friggin belt....
Tribology is a very complicated field of knowledge.
it's called outsourcing, people. The lowest bidder wins. OEM isn't always the answer.
Gates or Goodyear Gatorback is the obvious choice. Dayco too, but I personally have never had good luck with them.
Not to mention that oil is so much more complex than a friggin belt....
Tribology is a very complicated field of knowledge.
#18
Lexus Test Driver
iTrader: (1)
Right, because Toyota actually manufactures Belts and Motor Oil themselves...
it's called outsourcing, people. The lowest bidder wins. OEM isn't always the answer.
Gates or Goodyear Gatorback is the obvious choice. Dayco too, but I personally have never had good luck with them.
Not to mention that oil is so much more complex than a friggin belt....
Tribology is a very complicated field of knowledge.
it's called outsourcing, people. The lowest bidder wins. OEM isn't always the answer.
Gates or Goodyear Gatorback is the obvious choice. Dayco too, but I personally have never had good luck with them.
Not to mention that oil is so much more complex than a friggin belt....
Tribology is a very complicated field of knowledge.
#19
Lexus Champion
iTrader: (6)
Join Date: Nov 2002
Location: Mississauga,Ontario,Canada
Posts: 3,488
Likes: 0
Received 8 Likes
on
8 Posts
Having a degree to tell you one belt is better than another would be a complete waste of $20 000 , don't you think?
If it is cheaper works better and lasts longer would that not be all that is needed to decide on what makes a belt good or bad?
If it is cheaper works better and lasts longer would that not be all that is needed to decide on what makes a belt good or bad?
#20
Lexus Champion
Maybe a domestic carmaker goes with the absolute lowest bidder, but Toyota - especially for Lexus applications - goes with top-quality belt manufacturers such as Mitsuboshi. What do you know about tribology? Did you take any university courses on tribology? How about metrology and tolerance design? Any experience there?
Thread
Thread Starter
Forum
Replies
Last Post