Nagisa Auto Front Camber Blocks... Any Good?
#1
Thread Starter
Driver School Candidate
iTrader: (1)
Joined: Mar 2008
Posts: 25
Likes: 0
From: Hawaii
Nagisa Auto Front Camber Blocks... Any Good?
wattup peeps... just wondering if the Nagisa auto front camber blocks for a UCF20 really adds 2-3 more degrees in angle.... does anyone have pics of them installed on their ride??? Let me know peeps.. Thanks..
#3
Robz their page says they add 4-5... But I've never used them so I couldn't verify that.
PD I assume he means these ones, 2/3rds the way down the page:
"Span of adjustable range of front camber narrow the offset being able to point to the lower ball joint section, by the fact that you install, it actualizes the negative camber of +4 - 5 degrees.
Because thickness is 20mm, stroke width is raised.
(The low down of 20mm OK)"
PD I assume he means these ones, 2/3rds the way down the page:
"Span of adjustable range of front camber narrow the offset being able to point to the lower ball joint section, by the fact that you install, it actualizes the negative camber of +4 - 5 degrees.
Because thickness is 20mm, stroke width is raised.
(The low down of 20mm OK)"
#4
that's nothing more than a Roll Center Adapter.
YouZealand sold them as part of their SS Kit for a while for ~$500.
iirc AutoFashion is coming out with a set (front/rear) for <$400 soon, sometime round december i was told.
YouZealand sold them as part of their SS Kit for a while for ~$500.
iirc AutoFashion is coming out with a set (front/rear) for <$400 soon, sometime round december i was told.
Thread
Thread Starter
Forum
Replies
Last Post
Gville350
Suspension and Brakes
27
01-31-14 07:09 PM