Intake Hose
#1
Intake Hose
OEM Part # 17881-50010
This is the "accordion" intake hose between the AFM housing (aluminum) & the plastic Manifold Intake.
Mine was cracked & brittle & needs replacing. What are my options other than the $50.00 oem??
It is a 4" OD & around 4 3/4" long.
94 LS.
This is the "accordion" intake hose between the AFM housing (aluminum) & the plastic Manifold Intake.
Mine was cracked & brittle & needs replacing. What are my options other than the $50.00 oem??
It is a 4" OD & around 4 3/4" long.
94 LS.
Last edited by damon; 08-24-09 at 10:32 PM.
#2
I bet you could have a silicone hose made by one of the many capable hose makers out there. It will probably cost MORE than $50.00 though. It would be a non-accordion style though, for better flow. Maybe spectre has something.
#4
What's the inside diameter? This is most important since the wall thickness on anything aftermarket is going to vary and this hose slips "over" the AFM and manifold intake. I was going to suggest just buying a foot of marine exhaust hose from your local West Marine store. There's one in Reno if that's close to you.
#5
JimsGX,
You are ofcourse correct. Inner Diameter is the most important measurement.
This is promising:
http://intakehoses.com/Merchant2/mer...Category_Code=
You are ofcourse correct. Inner Diameter is the most important measurement.
This is promising:
http://intakehoses.com/Merchant2/mer...Category_Code=
#7
JimsGX,
You are ofcourse correct. Inner Diameter is the most important measurement.
This is promising:
http://intakehoses.com/Merchant2/mer...Category_Code=
You are ofcourse correct. Inner Diameter is the most important measurement.
This is promising:
http://intakehoses.com/Merchant2/mer...Category_Code=
Trending Topics
#8
I'm sure my local Pick A Part has it for much cheaper. If you want I can check it out for you. Only thing is that shipping may drive the price up again.
#10
Used makes no sense to me.
ID" appears to be 3.5".
http://www.siliconeintakes.com/produ...177dfbe57e039a
\
This OEM piece is 4.5" long.
ID" appears to be 3.5".
http://www.siliconeintakes.com/produ...177dfbe57e039a
\
This OEM piece is 4.5" long.
Last edited by damon; 08-27-09 at 11:39 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Kyle4207
IS F (2008-2014)
6
12-22-11 10:01 PM