RPM Sensor
#1
Driver School Candidate
Thread Starter
Join Date: Feb 2012
Location: Ga
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
RPM Sensor
93 LS400 Check engine Light is on, car idles fine but when reaved up to a high RPM it gets a little rough, OBD2 gives an RPM Sensor Code. Should I change the sensor and if so where do I find it?
Any help would be greatly appreciated.
Jesse
Any help would be greatly appreciated.
Jesse
#5
My 91 had the same problem. There was a code reading for the rpm speed sensor. The driver side Rpm speed sensor was cut by one of the pulley belts. there are two rpm speed sensors and they are connected to the distributor. I went to the junkyard and replaced mines yesterday. the check engine turned right off.
http://www.lexls.com/tutorials/ignit...tor_rotor.html
its connected to the silver bracket that goes under the distributor rotor. Best of luck.
http://www.lexls.com/tutorials/ignit...tor_rotor.html
its connected to the silver bracket that goes under the distributor rotor. Best of luck.
Thread
Thread Starter
Forum
Replies
Last Post