2000 LS new bushings in the rear, which ones?
#1
Lead Lap
Thread Starter
2000 LS new bushings in the rear, which ones?
the heim joint bushing which is pressed into the hub carrier, for the camber arm is worn and can feel the play. Also the rear most upper control arm bushing has decent forward backward play when i rock the tire on an angle. I see the control arms comes as a subassembly with new BJ and two bushings so I will get that for both sides, 180 at lex of south atlanta (cheaper anywhere else?)
Where do I get just the bushing to press into the carrier? looks lik its called knuckle bushing.
http://www.roca-usa.com/product.php?...roducts_id=778
i only need the knuckle side not the chasis side as there is a heim joint there.
Also, the seal between the CV shaft and hub has throw grease all over the suspension components, is the grease seal dunzo on it, or will fixing the suspension ensure that it doesnt wobble and squeeze the grease out?
Where do I get just the bushing to press into the carrier? looks lik its called knuckle bushing.
http://www.roca-usa.com/product.php?...roducts_id=778
i only need the knuckle side not the chasis side as there is a heim joint there.
Also, the seal between the CV shaft and hub has throw grease all over the suspension components, is the grease seal dunzo on it, or will fixing the suspension ensure that it doesnt wobble and squeeze the grease out?
#6
Lead Lap
Thread Starter
its a spherical joint, its in the knuckle pressed in, camber arm attaches to it.
Founda thread in the GS forum outlining it but ofcourse didnt bookmark it.
Founda thread in the GS forum outlining it but ofcourse didnt bookmark it.
Trending Topics
#8
Lead Lap
Thread Starter
I have it, Lexus wants you to buy the whole shebang, nuhuh, Got new bushigns on order. 100 bucsk both sides, dont need the inner one though if someone wants em cheap.
#15
Lead Lap
Thread Starter
Also need the bushings that the Adus 578 kit shows, however theirs is only up to 95 cars. I need those for a 00.
Can get the whole arm with bushings and BJ from lex of south atl for 180 but...im cheap, and got a press. Actually, jsut rembered about CL discount, i shall give that a try
and liek i mentioned because of the worn bushing si was having grease come out where the driveshaft meets the spindle.
IS the oil seal toast or now that its not wobbling should it be ok?
Can get the whole arm with bushings and BJ from lex of south atl for 180 but...im cheap, and got a press. Actually, jsut rembered about CL discount, i shall give that a try
and liek i mentioned because of the worn bushing si was having grease come out where the driveshaft meets the spindle.
IS the oil seal toast or now that its not wobbling should it be ok?
Last edited by Greg5OH; 03-26-14 at 01:43 PM.