When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
my damper setting is 20 front 15 rear, but I'm on air and I'm 2nd gen 97. what I've always gone by is to never set it to full soft or full hard. you have up to 30 clicks, soft to hard.
I say play with the settings though if you don't have the extenders for the rear, it will be difficult with the seats installed.
my damper setting is 20 front 15 rear, but I'm on air and I'm 2nd gen 97. what I've always gone by is to never set it to full soft or full hard. you have up to 30 clicks, soft to hard.
I say play with the settings though if you don't have the extenders for the rear, it will be difficult with the seats installed.
Once installed what do you have to remove to get access to adjustment with extenders?
i set the pre-load myself according to the video. used the spanner wrench as an adjustment gap once i turned to lower perch in as far as i could by hand....then tightened lock nut. i assume close is good enough unless u get into counting threads or measuring the spring length?